Treatment-Op

The cavo-surface angle of preparation for amalgam restoration is:

Length of self-threading pins must be equals in both tooth and restoration by a depth of:

To prevent the discoloration under amalgam filling:

Rubber dam is contraindicated in:

In cavity preparation, the width of the cavity is:

Class II cavity preparation will be restored by composite restoration all Cavo-surface angles should be:

Want to restore tooth with amalgam pins, the number of pins per cusp:

Patient came to replace all old amalgam filling and he had sever occlusal attrition. the best replacement is:

The best matrix to be used for amalgam restoration in MOD cavity is:

We do glazing layer above GIC:

We do incremental composite technique to:

tunnel tooth preparation is:

When composite is placed over an RMGI material, this technique is called:

Features that allow adequate access and visibility of preparation and extension of the cavity:

For treatment of broken pins, the alternative location will be at least:

Selection of shade for composite is done:

Cavity varnish should be applied at least in:

The most retentive type of pins:

The ideal amount of dentin required between an amalgam restoration and the pulp is:

The divergence should be mesiodistally for an amalgam restoration, if the remaining proximal marginal ridge is:

After applying rubber dam, you noticed wrinkles of the sheet, that may indicate:

If the Holes of rubber dam are too close, the may lead to:

For anterior porcelain inlay the groove is placed on:

The best barrier between a restorative material and the pulp:

Which of following is used for polishing the proximal surface in class III?

Which Matrix can be used in class III restoration?

Which type of sugar can be used in caries prevention?

Which of the following is an indication of PRR?

For a Class III composite resin prepared lingually, the cavo-surface margin of the cavity prepared as beveled to:

In class IV composite restorations, the width of the bevel is determined by:

The outline form in modified class III composite restoration is determined by:

The preparation of inlay is:

In case of indirect tooth –colored onlay, a temporary resin is given. Which cement should be avoided?

Patient presented with inter-proximal discoloration without cavitation. No active caries is present. Your management:

What is the major difference of preparation between a class V cavity for amalgam and that for composite:

The most important factor for the success of sealant is:

You did RCT through full crown, what Is the best restoration?

The best base under composite in class I with deep cavity?

Best liner under composite in deep cavity:

Matrix band should be over margin by:

ETCHANT of most dentine bonding systems is applied for: